Fujitsu Eternus DX100 S3 User Manual page 289

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-affinity
The following example only displays the mapping that is set to the host named "HBA5":
CLI> show host-affinity
CM#1 CA#1 Port#1 (Host Affinity Mode Enable)
Host
No. Name
---- ---------------- ---- ---------------- -----------
5 HBA5
The following is an example of LUN Overlap volumes. This means the same volume identifier in the
"LUN001" LUN group is defined in the "LUN002" LUN group. In this case, "Yes" is displayed for both the
"LUN001" and "LUN002" LUN groups. In other LUN groups, "No" is displayed:
CLI> show host-affinity
CM#0 CA#0 Port#0 (Host Affinity Mode Enable)
Host
No. Name
---- ---------------- ---- ---------------- -----------
1 HBA1
2 HBA2
3 HBA3
-host-name HBA5
LUN Overlap
LUN Group
No. Name Volumes
6 LUN006 No
-port 000
LUN Overlap
LUN Group
No. Name Volumes
1 LUN001 Yes
2 LUN002 Yes
3 LUN003 No
289
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0