Fujitsu Eternus DX100 S3 User Manual page 173

Chapter 3 Configuration Settings and Display
3.2 Volume Management > set volume-exc
-mode
■ Example(s)
The following example enables the EXC function for all of the volumes that are registered in the ETERNUS DX
as well as the volumes that can be applied to the EXC setting:
CLI> set volume-exc -mode disable -all
The following example disables the EXC function for volumes 0, 2, 5, 9, 10, and 11:
CCLI> set volume-exc -volume-number 0,2,5,9-11 -mode disable
volume_numbers
Volume number
volume_name
Volume name
This parameter specifies whether to enable the EXC function for the volume.
The EXC function is not used regardless of the setting of each volume when the EXC function is
disabled for the ETERNUS DX.
enable The EXC function is enabled.
disable The EXC function is disabled.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
173
P2X0-1210-05ENZ0