Fujitsu Eternus DX100 S3 User Manual page 454

Chapter 4 Copy Function Settings and Display
4.1 Advanced Copy Management > set rec-buffer
-remote-boxid
-buffer-size Optional. This parameter specifies the REC buffer size. This parameter must be specified for the
-buffer-type
When the specified number is already used, existing set values are overwritten.
Optional. This parameter specifies the Box ID of a single remote storage system that is to be
defined. Only one Box ID can be specified at a time. Only one Send/Receive REC buffer transfer
can be set using the Box ID of a single remote storage system. This parameter must be
specified for the initial setup. If omitted, this parameter value is not changed.
• Box IDs use a maximum of 40 alphanumeric characters, spaces, and pound key characters
(#).
• All alphabetic characters are handled as uppercase.
• The pound key characters (#) are automatically appended when the input characters are
less than 40.
storage_system_box_id
Remote storage system Box ID
initial setup. If omitted, this parameter value is not changed. The size of each REC buffer can be
selected as follows:
ETERNUS DX100 S3: 128MB
ETERNUS DX200 S3: 128MB, 256MB, and 512MB
ETERNUS DX500 S3/DX600 S3: 128MB, 256MB, 512MB, 1024MB, and 2048MB
ETERNUS DX200F: 128MB, 256MB, 512MB
Optional. This parameter specifies the REC buffer type. This parameter must be specified for
the initial setup. If omitted, this parameter value cannot be changed.
receive Use as a Receive buffer.
send Use as a Send buffer.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
454
P2X0-1210-05ENZ0