Set Raid-Group - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.1 RAID Group Management > set raid-group

set raid-group

This command changes the information of an existing RAID group.
■
Syntax
set raid-group {-rg-number
[-key-group {enable|disable}]
■ Parameter
-rg-number
or
-rg-name
-name
-assigned-cm
-key-group
rg_number
| -rg-name
This parameter specifies RAID group identifiers.
Only one RAID group identifier can be specified when changing a RAID group alias name. One
or more RAID group identifiers can be specified when changing the assigned CM. For details,
refer to "1.2.9 RAID Group Syntax" (page
rg_number
RAID group number
rg_name
RAID group name
Optional. This parameter specifies the new RAID group name. If this parameter is omitted, the
name is not changed. For details, refer to
name
RAID group name
Optional. This parameter specifies the assigned controller module number of the RAID group. If
"auto" is specified, the fixed controller, which is calculated automatically by the system, is
assigned. If this parameter is omitted, the assigned CM is not changed.
0 Controller module#0
1 Controller module#1
auto Automatically (default)
Optional. This parameter specifies whether to use the key group. If omitted, the existing
setting is not changed.
enable The key group is used (the SED authentication key that is managed by the key
server is used).
disable The key group is not used (the common key in the ETERNUS DX is used).
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
rg_name name
} [-name
25).
"1.2.5 Alias Name Syntax" (page
77
] [-assigned-cm {0|1|auto}]
23).
P2X0-1210-05ENZ0