Create Host-Sas-Address - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > create host-sas-address

create host-sas-address

This command registers a host alias for the SAS (Serial Attached SCSI) address that is used to identify a SAS
type HBA (Host Bus Adapter). This alias can then be used instead of a numeric SAS address when mapping
volumes to hosts.
Only one SAS address can be specified at any given time. The maximum number of available definitions
depends on the number of available host interface ports and the model.
■ Syntax
create host-sas-address -address
[-host-response-number
[-host-group-number
-new-host-group-name
■ Parameter
-address
-name
-host-response-number
or
-host-response-name
address
host_response_number
host_group_number
new_host_group_name
This parameter specifies the SAS address, which is a 16 character hexadecimal number that
corresponds to a HBA.
Example: -address 500605b000b5f344
address
SAS address
This parameter specifies the SAS address alias. For details, refer to
(page 23).
name SAS address alias
Optional. This parameter specifies a host response identifier. Only one identifier can be
specified at any given time. For details, refer to
omitted, the existing setting is not changed.
host_response_number
Host response number
host_response_name
Host response name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
name
-name
| -host-response-name
host_group_name
| -host-group-name
]
"1.2.13 Host Response Syntax" (page
265
host_response_name
]
|
"1.2.5 Alias Name Syntax"
28). If
P2X0-1210-05ENZ0