Fujitsu Eternus DX100 S3 User Manual page 242

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
-ipv4-flag
-ip
-netmask
-gateway
-ipv6-flag
-link-local-ip
Optional. This parameter specifies whether to use an IPv4 address. "disable" cannot be
specified for this parameter if "disable" is specified for the "-ipv6-flag" parameter. This parame-
ter can be specified for the multiple IP address setting.
enable An IPv4 address is used.
disable An IPv4 address is not used.
Optional. This parameter specifies the IP address that is used to connect to an iSCSI network
using IPv4 standard notation (a base 256 "d.d.d.d" string). If omitted, the existing setting is
not changed. This parameter can be specified for the multiple IP address setting.
Example: -ip 192.168.1.1
ip_address
IP address
Optional. This parameter specifies the subnet mask that is used to connect to an iSCSI network
using IPv4 standard notation (a base 256 "d.d.d.d" string). If omitted, the existing setting is
not changed.
This parameter can be specified for the multiple IP address setting.
Example: -netmask 255.255.255.0
netmask Subnet mask
Optional. This parameter specifies the gateway server address using IPv4 standard notation (a
base 256 "d.d.d.d" string). If omitted, the existing setting is not changed.
This parameter can be specified as a parameter for the multiple IP address setting.
Example: -gateway 10.1.0.250
gateway
Gateway server address
Optional. This parameter specifies whether to use an IPv6 address. "disable" cannot be
specified for this parameter if "disable" is specified for the "-ipv4-flag" parameter.
This parameter can be specified as a parameter for the multiple IP address setting.
enable An IPv6 address is used.
disable An IPv6 address is not used.
Optional. This parameter specifies a link local address in IPv6 format. If omitted, the existing
setting is not changed. If IPv6 addresses are used and a link local address is not set when this
parameter is omitted, an IP address is automatically created and set based on the WWN of the
ETERNUS DX. This parameter can be specified as a parameter for the multiple IP address set-
ting. When IPv6 is enabled and this parameter is specified as a parameter for the multiple IP
address setting without a link local address, a link local address is not automatically created.
Example: -link-local-ip fe80::250
ip_address Link local address
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
242
P2X0-1210-05ENZ0