Network Management; Network Settings - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display

5.2 Network Management

5.2 Network Management
This section explains commands related to the following network operations:
• System network configurations
• SNMP configurations
• SMI-S configurations
• Secure server keys
5.2.1

Network Settings

This section explains the commands related to network connectivity.
For the factory default network setting, the default IP address is set for the MNT port of the master CM. If the
default setting is used, the following functions are unavailable:
• SNMP Agent basic settings
• Email notification settings
• Syslog settings
• RADIUS settings
• Remote support settings (only for ETERNUS Web GUI)
• Network settings update except for the IP address
• Settings for a firmware update from the peer storage system (only for ETERNUS Web GUI)
• SMI-S settings
• AIS Connect settings
• Audit log
• Key management server linkage
• Activation of the NPT in date and time settings
• Firmware hot swapping
• Memory addition
• Hot expansion and hot reduction of the CAs (only for the ETERNUS DX100 S3/DX200 S3 and the ETERNUS
DX200F)
To make these functions available, set the network by executing the "set network" command. This releases
the factory default network setting. Whether the factory default network setting is set can be determined by
executing the "show network" command. If the factory default network setting is set, a message informing
that the network setting is required appears when one of the functions above is executed or enabled. A mes-
sage that prompts the network setting appears at login.
491
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0