Show Diagnosis - Fujitsu Eternus DX100 S3 User Manual

Chapter 6 Information Settings and Display
6.4 Utility > show diagnosis

show diagnosis

This command displays the results of the diagnostic tests that have been run on the disks or RAID groups.
■
Syntax
show diagnosis -type { disks [ -disks {all |
raid-groups [-rg-number
■ Parameter
-type
-rg-number
or
-rg-name
-disks
■
Output
Summary results of the disk diagnosis
Diagnosis Status
Progress
Method
Diagnosis Count
Location
Diagnosis Status
rg_numbers
| -rg-name
This parameter specifies the type of diagnostic results to be displayed. Only one type can be
displayed by a single command.
disks The diagnostic results of disks
raid-groups The diagnostic results of RAID groups
Optional. This parameter specifies the RAID group identifiers to be displayed and can only be
specified in conjunction with the "-type raid-groups" parameter. One or more RAID groups can
be specified at the same time. For details, refer to
omitted, all the RAID groups are selected.
rg_numbers
RAID group number
rg_names RAID group name
Optional. This parameter specifies the disks to display more detailed diagnostic results of the
disks and can only be specified in conjunction with the "-type disks" parameter. One or more
disks can be specified at the same time. For details, refer to
omitted, a summary list of all the disks is displayed.
all All the drives
disks
Drive
Diagnosis status
Diagnosis progress
Diagnosis mode
Loop count for diagnosis
Disk number
Executing status
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
disks
} ] |
rg_names
] }
"1.2.9 RAID Group Syntax" (page
704
25). If
"1.2.4 Drive Syntax" (page 23). If
P2X0-1210-05ENZ0