Set Host-Path-State - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-path-state

set host-path-state

This command changes the access availability status from hosts that are associated to the specified host
interface port that is defined in the mapping and changes the path access status.
■ Syntax
set host-path-state -port
-state {offline|online}
■ Parameter
-port
-host-number
or
-host-name
-state
■ Example(s)
The following example does not all allow access for the host#0 of the host interface port (CM#1 CA#0
Port#0):
CLI> set host-path-state -port 100 -host-number 0 -state offline
xyz
{-host-number
This parameter specifies the host interface port. Multiple parameters can be set by
separating each one by a comma (,).
Example: -port 000,100
For details, refer to "1.2.15 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the
host port number.
Example: 123 (host port#3 of CA#2 on CM#1)
This parameter specifies the identifier of the related host. Multiple parameters can be set at
the same time. For details on the contents that can be entered, refer to
(page 27). When multiple parameters are set, the parameters must be set to correspond to the
order of the parameters that are specified for the "-port" parameter.
host_numbers
Host number
host_names
Host name
This parameter specifies whether to allow access from the target host.
offline Access is not allowed.
online Access is allowed.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
host_numbers
| -host-name
335
host_names
}
29).
"1.2.11 Host Syntax"
P2X0-1210-05ENZ0