Create Raid-Group - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.1 RAID Group Management > create raid-group

create raid-group

This command creates a RAID group with the specified RAID group name, RAID level and disks. When
registering a hot spare, refer to the "set global-spare" or the "set dedicated-spare" command.
■ Syntax
create raid-group -name
[-stripe-depth { 64kb | 128kb | 256kb | 512kb | 1024kb }] [-fr-consist { (3D+2P)x2+1HS | (6D+2P)x2+1HS |
(9D+2P)x2+1HS | (12D+2P)x2+1HS | (5D+2P)x4+1HS | (13D+2P)x2+1HS | (3D+2P)x6+1HS }]
■
Parameter
-name
-disks
-level
-assigned-cm
alias_name
-disks
This parameter specifies the alias name of a RAID group. Only one name can be specified. For
details, refer to "1.2.5 Alias Name Syntax" (page
alias_name
RAID group name
This parameter specifies which disks will form the RAID group. For details, refer to
Syntax" (page 23).
disks
Drive
This parameter specifies the RAID level.
0 RAID0
1 RAID1
5 RAID5
6 RAID6
10 RAID1+0
50 RAID5+0
6fr RAID6-FR (Fast Recovery)
Optional. This parameter specifies the assigned controller (CM number) of the specified RAID
group. If "auto" is specified, the fixed controller, which is calculated automatically by the
system, is assigned. If this parameter is omitted, the "auto" mode is set.
0 Controller module#0
1 Controller module#1
auto Automatically (default)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
disks
-level {0|1|5|6|10|50|6fr} [-assigned-cm {0|1|auto}]
23).
75
"1.2.4 Drive
P2X0-1210-05ENZ0