Fujitsu Eternus DX100 S3 User Manual page 51

Chapter 2 Status Display
2.1 Storage System Status > show fru-ce
SFP Information (For FC, iSCSI 10G, and FCoE)
Temperature
Voltage
Current
TX Power
RX Power
CM#n CA#m Port#l Information (n: The controller module number, m: The Channel Adapter number, l:
The port number)
(For NAS)
Port Type
Status/Status Code
CA Active
EC
CA Next EC EC number of the stand-by firmware (the generation number of the firmware after the
MAC Address
SFP Type
SFP Information (For 10G NAS)
(The following information does not appear when 1G NAS is used)
Temperature
Voltage
Current
TX Power
RX Power
Temperature (Present, Warning(Low/High), and Alarm(Low/High))
Voltage (Present, Warning(Low/High), and Alarm(Low/High))
Current (Present, Warning(Low/High), and Alarm(Low/High))
Transmitter power (Present, Warning(Low/High), and Alarm(Low/High))
Receiver power (Present, Warning(Low/High), and Alarm(Low/High))
Host interface port type (NAS)
Host interface port status and the status code
EC number of the active firmware (the current operating firmware)
next power cycle)
MAC address of the port
SFP type of the port (for 10G NAS). (This information does not appear when 1G NAS is
used)
Temperature (Present, Warning(Low/High), and Alarm(Low/High))
Voltage (Present, Warning(Low/High), and Alarm(Low/High))
Current (Present, Warning(Low/High), and Alarm(Low/High))
Transmitter power (Present, Warning(Low/High), and Alarm(Low/High))
Receiver power (Present, Warning(Low/High), and Alarm(Low/High))
51
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0