Create Snmp-User - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display
5.2 Network Management > create snmp-user

create snmp-user

This command creates SNMP user settings.
■
Syntax
create snmp-user -name
[-authentication-method {md5 | sha}] [-encryption {enable | disable}][-encryption-method {des | aes}]
■ Parameter
-name
-view
-authentication
-authentication-method
-encryption Optional. This parameter specifies the encryption mode. If this parameter is set to enable, the
user_name
-view {
This parameter specifies the SNMP user name. Up to 10 SNMP user names can be specified. It
is a unique name. Between 8 and 32 characters can be specified for a name.
user_name
SNMP user name
This parameter specifies the MIB view name. Up to 32 characters can be specified for a view
name. Specify a null character ("") to not specify a view name.
mib_view_name
MIB view name
"" An MIB view name is not specified.
Optional. This parameter specifies whether to enable authentication. If it is specified, the "-
authentication-method" and "-encryption" options can be specified. In addition, the ETERNUS
DX confirms the authentication password. Between 8 and 64 characters can be used for the
password. If omitted, it is enabled.
enable Authentication is enabled (default).
disable Authentication is disabled.
Optional. This parameter specifies which authentication method is used. One of the following
methods can be selected.
md5 MD5 (default)
sha SHA
ETERNUS DX confirms the encryption password. Between 8 and 64 characters can be used for
the password.
enable Encryption is enabled (default).
disable Encryption is disabled.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
mib_view_name
|""} [-authentication {enable | disable}]
525
P2X0-1210-05ENZ0