Delete Nas-Interface - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.2 Network Interface > delete nas-interface

delete nas-interface

This command deletes a NAS interface.
■
Syntax
delete nas-interface { -nas-if-number
■ Parameter
-nas-if-number
or
-all
■
Example(s)
The following example shows settings for deleting NAS interfaces #2, #3, and #4:
CLI> delete nas-interface -nas-if-number 2-4
The following example shows settings for deleting NAS interfaces #2 and #5:
CLI> delete nas-interface -nas-if-number 2,5
The following example shows settings for deleting NAS interface #1:
CLI> delete nas-interface -nas-if-number 1
The following example shows settings for deleting NAS interfaces of all numbers:
CLI> delete nas-interface -all
nas-if-number
This parameter specifies the NAS interface to be deleted. When the "nas-if-number" parameter
is used, multiple numbers can be specified by inserting a hyphen (-) or a comma (,) between
them as a delimiter. When the "-all" parameter is used, all the NAS interfaces on the ETERNUS
DX are deleted.
A NAS interface that does not exist cannot be specified.
nas-if-number
NAS interface number
-all All NAS interfaces
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
| -all }
759
P2X0-1210-05ENZ0