Fujitsu Eternus DX100 S3 User Manual page 227

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set fc-parameters
-connect
-rate
-loop-id-assign
-loop-id
-frame-size Optional. This parameter specifies the FC frame size. If omitted, the existing setting is not
Optional. This parameter specifies the connection condition of the FC port. If omitted, the
existing setting is not changed. The default value is a loop (FC-AL) connection.
Specify "fabric" for 16Gbit/s direct connections.
loop Loop connection (default)
fabric Fabric connection
Optional. This parameter specifies the FC transfer rate. If omitted, the existing setting is not
changed.
auto Auto negotiation
4g 4Gbit/s
8g 8Gbit/s
16g 16Gbit/s
Optional. This parameter specifies how to assign the loop ID. It is only applicable when
"-connect loop" is specified. If omitted, the existing setting is not changed.
auto-ascending
It automatically assigns ascending order.
auto-descending
It automatically assigns descending order.
manual It assigns manually.
Optional. This parameter specifies the loop ID (a hexadecimal number). This is only applicable
when "-loop-id-assign manual" is specified. The range of values is between 0x00 and 0x7d (a
hexadecimal number). If omitted, the existing setting is not changed.
loop_id
Loop ID
changed. If the RA mode or Initiator mode is being set for the specified ports, this parameter
cannot be specified.
512 512 byte
1024 1024 byte
2048 2048 byte
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
227
P2X0-1210-05ENZ0