Set Eco-Mode - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.1 RAID Group Management > set eco-mode

set eco-mode

This command enables or disables the Eco-mode. The Eco-mode is a function that turns off the disk motor
when the disks are not being accessed. The Eco-mode function cannot be used unless the Eco-mode is
enabled.
■ Syntax
set eco-mode [-mode {enable | disable}]
■ Parameter
-mode
■ Example(s)
The following example enables the Eco-mode.
CLI> set eco-mode
The following example disables the Eco-mode:
CLI> set eco-mode
Optional. This parameter specifies if the Eco-mode is enabled. If omitted, the existing setting
is not changed.
enable Eco-mode is enabled.
disable Eco-mode is disabled.
-mode enable
-mode disable
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
90
P2X0-1210-05ENZ0