Port Group Syntax; Host Group Syntax - Fujitsu Eternus DX100 S3 User Manual

Chapter 1 Overview
1.2 The Command Syntax
1.2.16

Port Group Syntax

There are two methods to specify an port group identifier; an port group number or an port group name.
• Port group number
An port group number is automatically created by the system when an port group is created. This is a
decimal number. Port group numbers can be displayed by using the "show port-groups" command.
Port group numbers may be combined as follows:
- A single port group number: 1
- A list of port group numbers: 2,8
- A hyphenated range of port group numbers from
- A list of port group numbers, port group ranges, or both, separated by commas (,). Spaces are not
permitted before or after commas (,): 1,3,10-12
• Port group name
An port group name must be specified when creating an port group. For details about the syntax, refer to
"1.2.5 Alias Name Syntax" (page
names. An port group name and an port group number cannot both be specified in the same command.
Do not include spaces before or after commas (,).
Two or more parameters might not be able to be specified for several commands. For details, refer to the
command descriptions.
1.2.17

Host Group Syntax

There are two methods to specify an host group identifier; an host group number or an host group name.
• Host group number
An host group number is automatically created by the system when an host group is created. This is a
decimal number. Host group numbers can be displayed by using the "show host-groups" command.
Host group numbers may be combined as follows:
- A single host group number: 1
- A list of host group numbers: 2,8
- A hyphenated range of host group numbers from
- A list of host group numbers, host group ranges, or both, separated by commas (,). Spaces are not
permitted before or after commas (,): 1,3,10-12
• Host group name
An host group name must be specified when creating an host group. For details about the syntax, refer to
"1.2.5 Alias Name Syntax" (page
names. An host group name and an host group number cannot both be specified in the same command.
Do not include spaces before or after commas (,).
Two or more parameters might not be able to be specified for several commands. For details, refer to the
command descriptions.
a
to z: 2-5
23). Some commands accept a comma-separated list of port group
a
to z: 2-5
23). Some commands accept a comma-separated list of host group
30
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0