Create User - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display
5.1 User Management > create user

create user

This command creates a new user account. User names that are already registered cannot be used.
■
Syntax
create user -name
■ Parameter
-name
-role
-function
■ Example(s)
This example changes the role of the user account named "user1" to the Account Admin Role:
CLI> create user -name user1 -role AccountAdmin -function enable
name role
-role [-function {enable | disable}]
This parameter specifies a unique name for the new user account. Usable characters are
alphanumeric (case-sensitive), exclamation mark (!), hyphen (-), underscore (_), and dot (.)
characters. A minimum of 1 letter and a maximum of 32 letters are required.
name
Name for the new user account
This parameter specifies the role. For details, refer to
role
Total Administrator role or user-defined role
Total Administrator role
Maintainer
SecurityAdmin
AccountAdmin
StorageAdmin
Administrator
Monitor
Software
User-defined role
Role that is created using the "create role" command.
Optional. This parameter specifies whether the user account will be enabled.
enable The user account created is enabled immediately (default).
disable The user account is created but not enabled.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
"5.1.1 Role" (page
Maintenance operator
Security administrator
Account administrator
ETERNUS DX administrator
Total administrator
Monitor
Software
475
467).
P2X0-1210-05ENZ0