Set Fcoe-Parameters - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set fcoe-parameters

set fcoe-parameters

This command sets up the parameters to control each Fibre Channel over Ethernet (FCoE) host interface port.
Host Affinity Mode can be changed by using this command.
■ Syntax
set fcoe-parameters -port {
[-frame-size {512|1024|2048}] [-host-response-number
-host-response-name
[-reserve-cancel {enable | disable}] [-fcf-vlan-id {enable | disable}] [-fcf-vlan-id-value {0 - 4095}]
[-fcf-fabric-name {enable | disable}] [-fcf-fabric-name-value
■ Parameter
-port
-host-affinity
-rate
-frame-size Optional. This parameter specifies the FC frame size. If omitted, the existing setting is not
xyz
|all } [-host-affinity {enable|disable}] [-rate {10g}]
host_response_name
This parameter specifies the FCoE interface port number to be set up. Two or more ports can be
specified by separating them with a comma (,).
Example: -port 000,110
For details, refer to "1.2.15 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the
FCoE port number.
Example: "123" indicates CM#1-CA#2-Port#3
all All the FCoE interface ports
Optional. This parameter specifies the Host Affinity Mode. If omitted, the existing setting is not
changed.
The host affinity is the security capability of the system against host servers. By enabling Host
Affinity Mode, it can limit the access from hosts. If the Initiator mode is being set for the
specified ports, this parameter cannot be specified.
enable Host Affinity Mode is enabled.
disable Host Affinity Mode is disabled.
Optional. This parameter specifies the FC transfer rate. If omitted, the existing setting is not
changed.
10g 10Gbit/s
changed.
512 512 byte
1024 1024 byte
2048 2048 byte
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
host_response_number
] [-reset-scope {initiator-lun | target-lun}]
WWN
]
253
|
29).
P2X0-1210-05ENZ0