Fujitsu Eternus DX100 S3 User Manual page 247

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
-chap-ca
-chap-user-ca
-chap-ra
-chap-user-ra
-rec-line-no Optional. This parameter specifies the REC line number. If omitted, the existing setting is not
-rec-transfer-sync
Optional. This parameter specifies whether or not CHAP authentication is used. If omitted, this
setting is not changed. This parameter is used for the CA setting of CA/RA dual-purpose ports.
enable A CHAP authentication is used.
disable A CHAP authentication is not used.
Optional. This parameter specifies the user name for CHAP authentication. It is only applicable
if CHAP authentication is used. If omitted, this setting is not changed. Up to 255
alphanumerical characters and symbols can be used. When this parameter is specified, a
prompt that requires entering the CHAP user pass-word appears. To delete a registered CHAP
user name, specify a null character (""). This parameter is used for the CA setting of CA/RA dual-
purpose ports.
chap_user_name-ca
User name for CHAP authentication
"" The registered CHAP user name is deleted.
Optional. This parameter specifies whether or not CHAP authentication is used. this setting is
not changed. This parameter is used for the RA setting of CA/RA dual-purpose ports.
enable CHAP authentication is used.
disable CHAP authentication is not used.
Optional. This parameter specifies the user name for CHAP authentication. It is only applicable
if CHAP authentication is used. If omitted, this setting is not changed. Up to 63 alphanumerical
characters and symbols can be used. When this parameter is specified, a prompt to require
entering CHAP user password. To delete a registered CHAP user name, specify a null character
(""). This parameter is used for the RA setting of CA/RA dual-purpose ports.
chap_user_name-ra
User name for CHAP authentication
"" The registered CHAP user name is deleted.
changed. This parameter can only be specified for the ports that both of the following
conditions apply to: the Advanced Copy license has been registered and the port mode is RA
mode or CA/RA auto mode.
rec-line-no
REC line number (0 – 127)
Optional. This parameter specifies the synchronous mode for the copy transfer mode. If
omitted, the existing setting is not changed. This parameter can only be specified for the ports
that both of the following conditions apply to: the Advanced Copy license has been registered
and the port mode is RA mode or CA/RA auto mode.
enable An REC in synchronous transfer mode is permitted for the target CA port.
disable An REC in synchronous transfer mode is suppressed for the target CA port.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
247
P2X0-1210-05ENZ0