Fujitsu Eternus DX100 S3 User Manual page 274

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > create host-iscsi-name
-ip
-name
-chap-user
-host-response-number
or
-host-response-name
-cmdsn-count
Optional. This parameter specifies an IP address for the corresponding HBA. Only IPv4 standard
notation (a base 256 "d.d.d.d" string) and IPv6 format are allowed for the character string. The
types of IPv6 addresses that can be specified are global addresses (including 6to4 addresses),
link local addresses, and unique local addresses.
Example: -ip 192.168.1.10
Example: -ip fe80::223:4567:89ab:cdef
If omitted, any IP addresses are allowed. With the same iSCSI name designation, a specific IP
address is distinguished from the omitted one.
ip_address IP address for the corresponding HBA
This parameter specifies the iSCSI host alias. For details, refer to
(page 23).
name
Alias name which corresponds to the iSCSI host
Optional. When using CHAP authentication, this parameter is used to specify a CHAP user
name. Up to 255 alphanumerical characters and symbols can be used. If this parameter is
specified, then the command displays a CHAP user password prompt.
chap_user
CHAP user name
Optional. This parameter specifies a host response identifier. Only one identifier can be
specified at any given time. For details, refer to
omitted, the existing setting is not changed.
host_response_number
Host response number
host_response_name
Host response name
Optional. This parameter specifies the number of commands that can be accepted at the same
time.
unlimited Unlimited
20 20 commands
40 40 commands
80 80 commands
120 120 commands
180 180 commands
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
"1.2.13 Host Response Syntax" (page
274
"1.2.5 Alias Name Syntax"
28). If
P2X0-1210-05ENZ0