Fujitsu Eternus DX100 S3 User Manual page 385

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-lu-qos
-lu-qos-group
-event-number
-schedule-number
■ Example(s)
The following example sets the Port QoS and the default QoS schedule for the Port QoS:
CLI> set host-lu-qos -mode port-qos -port 000 -bandwidth-limit 15
The following example sets the Host QoS and the default QoS schedule for the Host QoS:
CLI> set host-lu-qos -mode host-qos -host-type iscsi -host-number 12 -bandwidth-limit 0
The following example sets the LU QoS and the default QoS schedule for the LU QoS (for a port with the Host
Affinity mode enabled):
CLI> set host-lu-qos -mode lu-qos -port 000 -host-number 12 -lu-qos-group 1
The following example sets the LU QoS and the default QoS schedule for the LU QoS (for a port with the Host
Affinity mode disabled):
CLI> set host-lu-qos -mode lu-qos -port 000 -lu-qos-group 1
Optional. This parameter specifies the LU QoS Group number to set for LU QoS.
When multiple values are specified, the number of values that are specified for this parameter
must be the same as the "-port" parameter or the "-host-number" parameter. Specify a null
character ("") to restore the initial setting.
lu_qos_group_numbers
LU QoS Group number
"" The initial setting is restored.
Optional. This parameter specifies the event number for the QoS schedule. A schedule number
is assigned to each event number. Any value between 1 to 7 can be specified. Multiple event
numbers can be specified. When multiple values are specified, the number of values that are
specified for this parameter must be the same as the "-port" parameter or the "-host-number"
parameter. If omitted, the default QoS schedule (event number 0) is set.
event_numbers
Event number
Optional. This parameter specifies the QoS schedule number. Multiple QoS schedule numbers
can be specified. When multiple values are specified, the number of values that are specified
for this parameter must be the same as the "-port" parameter or the "-host-number"
parameter. Specify a null character ("") to release the assigned QoS schedule.
schedule_numbers
QoS schedule number
"" The assigned QoS schedule is released.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
385
P2X0-1210-05ENZ0