Set Thin-Pro-Pool - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.3 Thin Provisioning Pool Management > set thin-pro-pool

set thin-pro-pool

This command changes the information of an existing Thin Provisioning Pool (Thin Provisioning Pool name, a
Thin Provisioning Pool warning, and a Thin Provisioning Pool attention).
■ Syntax
set thin-pro-pool {-pool-number
[-warning warning
■ Parameter
-pool-number
or
-pool-name
-name
-warning
-attention
■ Example(s)
The following example changes the Thin Provisioning Pool name from "TPP0001" to "TPP0010":
CLI> set thin-pro-pool -pool-name TPP0001 -name TPP0010
The following example changes the attention to 60% and the warning to 80% for Thin Provisioning Pool #02:
CLI> set thin-pro-pool -pool-number 02 -attention 60 -warning 80
pool_number
] [-attention attention
This parameter specifies the Thin Provisioning Pool identifier. Only one Thin Provisioning Pool
identifier can be specified.
pool_number
Thin Provisioning Pool number
pool_name
Thin Provisioning Pool name
Optional. This parameter specifies the new Thin Provisioning Pool name. If this parameter is
omitted, the name is not changed. For details, refer to
name
Thin Provisioning Pool name
Optional. This parameter specifies the warning level of the Thin Provisioning Pool. The settable
range is 5 – 99%. If this parameter is omitted, the warning level is not changed. The warning
level range should be equal to or higher than the "-attention" setting range.
warning
Warning level of the Thin Provisioning Pool
Optional. This parameter specifies the attention level of the Thin Provisioning Pool. The
settable range is 5 – 80%. If this parameter is omitted, the attention level is not changed. The
attention level range should be equal to or lower than the "-warning" setting range.
attention
Attention level of the Thin Provisioning Pool
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
pool_name
| -pool-name
]
"1.2.5 Alias Name Syntax" (page
186
name
} [-name ]
P2X0-1210-05ENZ0
23).