Create Nas-Share - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.1 Shared Folders > create nas-share

create nas-share

This command creates a NAS shared folder. The maximum number of shared folders that can be registered in
the ETERNUS DX is 256.
When using an authentication server, both CMs must be ready to communicate with the authentication
server. For each CM, the following requirements must be met.
• Using the "create nas-interface" command, an IP address is assigned to one or more ports.
• Using the port above, the CM is in a state capable of communicating with the authentication server.
If the above requirements are not met and the command fails, fulfill the requirements, and execute the
command again.
■
Syntax
create nas-share -name
{-volume-number
-service {cifs|nfs|nfs-cifs} [-access {r|rw}] [-oplocks {enable|disable}]
[-owner owner
[-nfs-allow-host {
[-cifs-allow-host {
■ Parameter
-name
-volume-number
or
-volume-name
name
volume_number
| -volume-name
] [-group group ] [-share {active|inactive}]
allow-host
| ""}]
allow-host
| ""}] [-cifs-deny-host {
This parameter specifies the name of the shared folder to be created using up to 250
characters.
Alphanumeric characters and symbols can be used. The following symbols and string cannot
be specified:
• "\", "/", ":", "*", "?", """, "<", ">", "|", "=", ",",";","[", and "]"
• Blank space
• Suffix string, "$bak"
name
This parameter specifies the NAS shared folder name.
This parameter specifies the NAS Thin Provisioning Volume in which the target shared folder is
to be created. Only one volume identifier can be specified simultaneously. For details, refer to
"1.2.10 Volume Syntax" (page
Only the NAS Thin Provisioning Volume can be specified.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
volume_name
}
deny-host
| ""}]
26).
737
P2X0-1210-05ENZ0