Fujitsu Eternus DX100 S3 User Manual page 228

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set fc-parameters
-host-response-number
or
-host-response-name
-reset-scope Optional. This parameter specifies the range of reset action. If omitted, the existing setting is
-reserve-cancel
-rec-line-no Optional. This parameter specifies the REC line number. If omitted, the existing setting is not
-rec-transfer-sync
-rec-transfer-stack
Optional. This parameter specifies a host response identifier. Only one host response identifier
can be specified at the same time. If omitted, the existing setting is not changed. If the RA
mode or Initiator mode is being set for the specified ports, this parameter cannot be specified.
For details, refer to "1.2.13 Host Response Syntax" (page
host_response_number
Host response number
host_response_name
Host response name
not changed. If the RA, Initiator mode is set, this parameter cannot be specified.
initiator-lun Reset (Cancel) the command request from the server that sent the command
reset request.
target-lun Reset (Cancel) the command request from all servers that are connected to the
port (regardless of whether the LUN is recognized).
Optional. This parameter specifies whether or not SCSI reservation (persistent reservation) is
canceled when host interface ports are reset. If omitted, the existing setting is not changed. If
the RA mode is set for the specified port, this parameter cannot be specified.
enable Reservations are canceled.
disable Reservations are not canceled.
changed. This parameter can only be specified for the ports that both of the following condi-
tions apply to: the Advanced Copy license has been registered and the port mode is the RA
mode or the CA/RA auto mode.
rec_line_no
REC line number (0 – 127)
Optional. This parameter specifies the synchronous mode for the copy transfer mode. If
omitted, the existing setting is not changed. This parameter can only be specified for the ports
that both of the following conditions apply to: the Advanced Copy license has been registered
and the port mode is the RA mode or the CA/RA auto mode.
enable An REC in synchronous transfer mode is permitted for the target CA port.
disable An REC in synchronous transfer mode is suppressed for the target CA port.
Optional. This parameter specifies the asynchronous stack mode for the copy transfer mode. If
omitted, the existing setting is not changed. This parameter can only be specified for the ports
that both of the following conditions apply to: the Advanced Copy license has been registered
and the port mode is the RA mode or the CA/RA auto mode.
enable An REC in asynchronous stack mode is permitted for the target CA port.
disable An REC in asynchronous stack mode is suppressed for the target CA port.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
28).
228
P2X0-1210-05ENZ0