Fujitsu Eternus DX100 S3 User Manual page 126

Chapter 3 Configuration Settings and Display
3.2 Volume Management > set volume
-encryption Optional. This parameter specifies whether the encryption by a CM is performed. When
-uid
-alua
■
Example(s)
The following example changes the volume named "VOL003". The new name is "VOLUME003":
CLI> set volume -volume-name VOL003 -name VOLUME003
The following example changes the volume named "VOL003" to "VOLUME003", enables copy protection, and
changes the attention level to 80:
CLI> set volume -volume-name VOL003 -name VOLUME003 -copy-protection enable -attention 80
"enable" is selected, the specified volume data is encrypted. If omitted, then it is handled as if
"disable" is selected. This does not mean that the volume data is decrypted when "disable" is
selected.
enable The volume data is encrypted.
disable No operation.
Optional. This parameter specifies the UID of the target volume. Thirty-two-digit hexadecimal
("0" to "9", "A" to "F", and "a" to "f") numbers can be specified. When "default" is specified, the
UID for the target volume does not change. The default UID is set for the target volume when
"original" is specified. If this parameter is omitted, the existing setting remains unchanged.
uid
UID of the target volume
default The UID of the target volume remains unchanged.
original The default UID is set.
Optional. This parameter specifies the ALUA setting for the target volume. If this parameter is
omitted, the existing setting remains unchanged.
follow-host-response
The ALUA setting follows the host response setting (default).
active The ACTIVE / ACTIVE setting takes priority regardless of the host response setting.
passive The ACTIVE-ACTIVE / PREFERRED_PATH setting takes priority regardless of the
host response setting.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
126
P2X0-1210-05ENZ0