Fujitsu Eternus DX100 S3 User Manual page 830

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
E0091
E0092
E0093
E0094
E0095
E0097
E0098
E0099
E0100
E0101
E0102
E0110
E0111
Not available under current SNMP settings.
The current SNMP mode does not permit this operation. Check the SNMP mode by using the "show snmp"
command.
The SNMP mode can be changed by using the "set snmp" command if necessary.
Not available under current operation mode conditions.
The current operation mode does not permit this operation. Check the operation mode by using the
"show enclosure-status" command.
The operation mode can be set by using the "start maintenance" command or canceled by using the "stop
maintenance" command if necessary.
Not available under current host affinity mode conditions.
The current host affinity mode does not permit this operation. The Host Affinity Mode can be set or can-
celed by using the "set fc-parameters" command, the "set sas-parameters" command, or the "set iscsi-
parameters" command if necessary.
Not available under current encryption status conditions.
The current encryption mode does not permit this operation. Check the encryption mode by using the
"show encryption" command.
The encryption mode can be set or canceled by using the "set encryption" command if necessary.
Not available under current e-mailing conditions.
The current e-mail send condition does not permit this operation. Confirm whether the e-mail send
condition is enabled by using the "show email-notification" command.
Set the e-mail environment by using the "set email-notification" command if necessary.
Not available under master controller module.
Could not execute this command from the master controller module. Try again from the slave controller
module, which can be accessed by the redundant IP address. For details, refer to the "show network"
command.
Not available under slave controller module.
Could not execute this command from the slave controller module. Try again from the master controller
module.
Not available under current system configuration.
The operation cannot be performed because of inconsistency with the system configuration.
The setting operation cannot be performed because the configuration is not applied. Reboot the ETERNUS
DX.
No space.
There is insufficient space available to allow the specified operation. Check the available space.
No memory.
Could not allocate working memory. Close other sessions and try again.
Not available under system disk status.
This message indicates that the execution condition does not match with the BUD (Bootup and Utility
Device) status. Confirm the BUD status by using the "show disks" command.
Resource does not exist.
Resources corresponding to the specified parameter do not exist. Check the resources associated with the
object identified in the details of this message
Resource is not reserved.
Resources corresponding to the specified parameter are not reserved. Check the status of resources
associated with the object identified in the details of this message.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
830
P2X0-1210-05ENZ0