Fujitsu Eternus DX100 S3 User Manual page 781

Chapter 7 NAS Function Setting and Display
7.5 Network Settings > set nas-route
-nas-if-number
■
Example(s)
The following example shows settings for assigning a static route to network 192.168.2.0:
CLI> set nas-route -net 192.168.2.0 -gw 192.168.0.1 -netmask 255.255.255.0 -nas-if-number 1
The following example shows settings for assigning a static route to host 192.168.2.10:
CLI> set nas-route -host 192.168.2.10 -gw 192.168.0.1 -nas-if-number 1
This parameter specifies one NAS interface that is to be used by the route.
• A NAS interface number that does not exist cannot be specified.
• If the specified NAS interface number is assigned to the port that configures the multipath,
both CMs must be set with the same route.
If the route on both CMs are set differently, the route information is not set correctly when a
line failure occurs and the CM communications path is switched.
nas-if-number
NAS interface number
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
781
P2X0-1210-05ENZ0