Show Mapping - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show mapping

show mapping

This command displays a list of the mapping definitions that associate the volumes with LUNs. Individual
volumes or host interface ports can be specified. This command cannot be used when Host Affinity Mode for
the host interface port is enabled.
■ Syntax
show mapping [-port {
■ Parameter
-port
-volume-number
or
-volume-name
■ Output
CM#x CA#y Port#z (Host Affinity Mode Disable)
LUN
Volume
Status
xyz |all}] [-volume-number
Optional. This parameter specifies the host interface ports. Two or more parameters can be
specified by separating them with a comma (,). If omitted, all the host interface ports are
displayed.
Example: -port 000,100
For details, refer to "1.2.15 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the host
port number.
Example: "123" indicates CM#1-CA#2-Host port#3
all All the host interface ports (default)
Optional. This parameter specifies the volume identifiers. One or more parameters can be
specified. For details, refer to
identifiers are displayed.
volume_numbers
Volume number
volume_names
Volume name
Host interface port. This is followed by a string that indicates whether the host affinity mode is
enabled.
Logical unit number (LUN)
Volume identifiers
No. Volume number
Name Volume name
Volume status
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
volume_numbers | -volume-name
"1.2.10 Volume Syntax" (page
299
volume_names
29).
26). If omitted, all the volume
P2X0-1210-05ENZ0
]