Appendix E Status List; General Status; Component Status; E.1 General Status - Fujitsu Eternus DX100 S3 User Manual

Appendix E
Status List
This appendix describes status meanings.
E.1

General Status

The meaning of each general status is described below.
Empty
Normal
Pinned Data
Unused
Warning
Maintenance
Error
Loop Down
Not Ready
Subsystem Down
Change Assigned CM
Unknown
E.2

Component Status

The meaning of each component status is described below.
Normal
Warning
Maintenance
Error
Normal (Inside unused parts)
Check1
Undefined
Unknown
Status
The ETERNUS DX is not defined or is not installed.
The ETERNUS DX is in normal state.
Pinned data exists.
A component is undefined.
A component requires preventive maintenance.
The ETERNUS DX is under maintenance.
A component with an error exists.
The ETERNUS DX is in BackEnd Down status.
A failure is detected in the ETERNUS DX. I/O from the host cannot be received
normally.
The ETERNUS DX is cannot be used.
Hot expansion and recovery of the CM is required.
A status other than the ones listed above.
Status
The component is operating normally.
The component requires preventive maintenance.
The component is under maintenance.
An error has occurred in the component.
There is an unused component that is installed in the ETERNUS DX.
The component is being rebooted.
The component is installed, but not used.
A status other than the ones listed above.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Description
Description
932
P2X0-1210-05ENZ0