Host Access Setting Procedure - Fujitsu Eternus DX100 S3 User Manual

Appendix D Basic Setting Examples
D.1 Settings When Using Volumes
D.1.2

Host Access Setting Procedure

This section is an example of how to set up host access. For more details, refer to
Management" (page
The following configuration example is used to explain the procedure.
Figure D.1 Host connection example
Host group HG01
Host
HBA1
HBA2
Host
HBA3
HBA4
Procedure
1
Change the connection topology of host interface ports 000 and 100 to fabric.
CLI> set fc-parameters -port 000,100 -connect fabric
2
Register a host WWN.
In this example, host WWNs named HBA1, HBA2, HBA3, and HBA4 are registered.
CLI> create host-wwn-name -wwn 40000000abc80e38 -name HBA1
CLI> create host-wwn-name -wwn 40000000abc80e00 -name HBA2
CLI> create host-wwn-name -wwn 40000000abc80e01 -name HBA3
CLI> create host-wwn-name -wwn 40000000abc80e02 -name HBA4
3
Group HBA1, HBA2, HBA3, and HBA4 together, and create a host group named HG01.
CLI> create host-group -name HG01 -host-type fc -host-name HBA1,HBA2,HBA3,HBA4
4
Group host interface ports 000 and 100 together, and create a port group named PG0001.
CLI> create port-group -name PG0001 -port 000,100
218).
Switch
Switch
Fibre Channel connection
A relationship is set between port group PG0001,
LUN group LUN001, and host group HG01.
924
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
ETERNUS DX Disk storage system
CA port group
LUN group LUN001
PG0001
Port 000
v0
Port 100
"3.5 Host Interface
v1
P2X0-1210-05ENZ0