Fujitsu Eternus DX100 S3 User Manual page 337

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-lu-qos-performance
Throughput(MB/s)
Delay Time(ms)
When the port number is specified (the host affinity mode is enabled):
x
CM#
Port Type
Host Affinity
Performance Monitoring
Monitoring Start Time
Monitoring Stop Time
IOPS
Throughput(MB/s)
Transfer amount per second for a port (in MB/s)
Ave Average transfer amount per second for a port
Min Minimum transfer amount per second for a port
Max Maximum transfer amount per second for a port
Delay time (in milliseconds)
Total Accumulated delay time for the start of a command due to the QoS control
of a port.
"Overflow" is displayed when a long time passes from the start of
performance measurement to the end of performance measurement and
the accumulated delay time exceeds the limit.
Ave Average delay time for a single command due to the QoS control of a port
y z
CA# Port#
Host interface port number
Port type
Host affinity (Enable: enabled, Disable: disabled)
Measurement status (ON: performance is being measured, OFF: performance
measuring is stopped)
Performance measurement start time
Performance measurement stop time
Number of I/Os per second for a port
Ave Average number of I/Os per second for a port
Min Minimum number of I/Os per second for a port
Max Maximum number of I/Os per second for a port
Transfer amount per second for a port (in MB/s)
Ave Average transfer amount per second for a port
Min Minimum transfer amount per second for a port
Max Maximum transfer amount per second for a port
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
337
P2X0-1210-05ENZ0