Delete Host-Group - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > delete host-group

delete host-group

This command deletes the specified host group(s).
• When "disable" is selected for the "-keep-host-mode" parameter, the host that belongs to the host group
is also deleted.
• Host groups for which mapping is set cannot be deleted.
■ Syntax
delete host-group {-host-group-number
keep-host-mode {enable|disable}]
■ Parameter
-host-group-number
or
-host-group-name
-keep-host-mode
■
Example(s)
The following example only deletes host group #1:
CLI> delete host-group
The following example deletes host group # 1 and host groups #3 to #5:
CLI> delete host-group
This parameter specifies the host group identifiers to be deleted. One or more parameters can
be specified at the same time. For details, refer to
host_group_numbers
Host group number
host_group_names
Host group name
This parameter specifies whether the hosts are deleted. If omitted, this parameter is handled
as though "enable" is selected.
enable Hosts are not deleted.
disable Hosts are also deleted
-host-group-number 1
-host-group-number 1,3-5
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
host_group_numbers
| -host-group-name
"1.2.17 Host Group Syntax" (page
315
host_group_names
} [-
30).
P2X0-1210-05ENZ0