Set Nas-Ad - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.7 Authentication Settings > set nas-ad

set nas-ad

This command configures settings for performing authentication using Active Directory.
• Kerberos authentication is used by default.
• This command is available only in the shared folder that uses CIFS or NFS/CIFS.
• When using an authentication server, both CMs must be ready to communicate with the authentication
server. For each CM, the following requirements must be met.
- Using the "create nas-interface" command, an IP address is assigned to one or more ports.
- Using the port above, the CM is in a state capable of communicating with the authentication server.
If the above requirements are not met and the command fails, fulfill the requirements, and execute the
command again.
• When this command ends successfully, the NAS engine restarts.
• If a setting is reconfigured after it was deleted, the previous setting value is not held.
• To create a new setting, the "-server1" parameter (or the "-server2" parameter or the "-server3"
parameter), the "-domain" parameter, and the "-user" parameter must be specified.
• If the host name is specified, the IP address is internally referenced from DNS. If the DNS settings are
changed, a reconfiguration may be required using this command.
• To delete a setting, the server IP address, the host name settings, the setting value for "-domain", and the
setting value for "-user" must be deleted. To delete the values for each of these settings, specify a null
character ("").
• If a null character ("") is not used for the "-user" parameter, a password must be entered after the
command is executed.
■ Syntax
set nas-ad [-server1 {
ip_address
[-server2 {
domain_name
[-domain {
■
Parameter
-server1
-server2
-server3
ip_address | host_name
host_name
| |""}] [-server3 {
user_id
|""}] [-user {
This parameter specifies the IP address or host name of the Active Directory authentication
server. To delete a setting, specify a null character (""). When any of the options (the "-server1"
parameter, the "-server2" parameter, or the "-server3" parameter) has been set, the "-domain"
parameter and the "-user" parameter must be set. If omitted, this parameter is not changed.
ip_address IP address
host_name Host name
"" The setting is deleted.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
|""}]
ip_address host_name
|
|""}]
795
|""}]
P2X0-1210-05ENZ0