Fujitsu Eternus DX100 S3 User Manual page 550

Chapter 5 System Settings and Display
5.2 Network Management > set email-notification
-text-count
-text1
. . .
-text10
address
Receiver email address
"" An address is deleted.
Optional. This parameter specifies the number of valid message lines. The fixed message is
output according to the specified one. Although this command is optional, it must be specified
when the fixed message is modified.
When 0 is specified, the fixed message is deleted.
count
Number of message lines
Optional. These parameters specify the fixed lines of the e-mail messages. The maximum
number of lines is 10 and the maximum size is a total of 255 bytes. The system sends the
message from the "-text1" parameter to the last parameter that is not blank as consecutive
messages. If any parameter is omitted, the corresponding value is not changed.
• The number after "-text" indicates the message line number. For example, "-text5" indicates
the 5th line. With the exception of the last line, two bytes of carriage return code (CR) are
added to each non-blank line.
Example: -text1 Hello -text2 Hello -text3 Hello
The total number of characters is 19 (5*3 + 2*2)
• The messages must be specified in ascending order beginning at "-text1".
Example: -text1 Hello
-text2 Morning.
-text3 bye.
• A null character ("") indicates a blank line.
Example: -text1 Hello
-text2 ""
-text3 bye
Result of this example:
line1 : Hello
line2 :
line3 : bye
* Line2 is blank.
• If a line includes a blank letter, both ends of the parameter must be enclosed in double
quotation marks ("). Double quotation marks are not include in the word count.
Example: -text1 Hello.
-text2 "This is your system." (20 letters)
• To include a double quotation mark, precede it by the back slash character. Back slash
characters are not include in the word count.
Example: -text1 abc\"def \"ghi (11 letters)
Result of this example:
abc"def"ghi
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
550
P2X0-1210-05ENZ0