Fujitsu Eternus DX100 S3 User Manual page 184

Chapter 3 Configuration Settings and Display
3.3 Thin Provisioning Pool Management > create thin-pro-pool
-rg-mode
-capacity
-disks
-assigned-cm
-encryption Optional. This parameter specifies whether the encryption by a CM is performed. When
-stripe-depth
This parameter specifies the method of selecting the disk when creating the RAID group.
auto The disk is automatically allocated. The capacity of the disk is specified with the -
capacity parameter.
manual The disk is manually allocated. The disk is specified with the -disks parameter.
Optional. This parameter specifies the disk capacity that is used to create a RAID group. This
parameter can only be specified when "-rg-mode auto" is selected.
capacity
Drive capacity
Optional. This parameter specifies which disks are used to configure the RAID group. This
parameter can only be specified when "-rg-mode manual" is selected. One or more disks can
be specified at the same time. For details, refer to
disks
Drive
Optional. This parameter specifies the assigned controller for the specified RAID group. This
parameter can only be specified when "-rg-mode manual" is selected. If "auto" is specified, the
fixed controller, which is calculated automatically by the system, is assigned. If this parameter
is omitted, "auto" mode is selected.
0 Controller module #0
1 Controller module #1
auto Automatically (default)
"enable" is selected, the specified pool volume data is encrypted. If omitted, then it is handled
as if "disable" is selected.
enable The pool volume data is encrypted.
disable The pool volume data is not encrypted.
Optional. This parameter specifies the stripe depth for the Thin Provisioning Pool that is to be
created. If omitted, then it is handled as if "64kb" is selected. The available values vary
depending on the RAID level and the number of drives. When "auto" is specified for the "-rg-
mode" parameter, only "64kb" can be specified.
64kb 64k Byte
128kb 128k Byte (Only for RAID 5 configurations of 10 or more disks, RAID0
configurations, and RAID1+0 configurations)
256kb 256k Byte (Only for RAID 5 configurations of 9 or less disks, RAID0 configurations,
and RAID1+0 configurations)
512kb 512k Byte (Only for RAID 5 configurations of 5 or less disks, RAID0 configurations,
and RAID 1+0 configurations)
1024kb 1024k Byte (Only for RAID0 configurations and RAID1+0 configurations)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
"1.2.4 Drive Syntax" (page
184
23).
P2X0-1210-05ENZ0