Fujitsu Eternus DX100 S3 User Manual page 845

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
E5355
E5356
E5357
E5358
E5359
E5360
E5361
E5362
E5363
E5364
E5365
E5366
E5367
E5368
E5369
E5370
E5371
Firmware update is in progress. The specified operation cannot be done.
The command cannot be processed because CFL is being performed.
Advanced copy resolution settings of the local storage and remote storage are different.
The storage system resolution is not the same between the copy source and the copy destination.
SDV was specified as a copy destination volume where the copy session is not SnapOPC+.
An SDV is specified for the copy destination of the non-SnapOPC copy session.
SDV was specified as a copy source volume in SnapOPC+.
An SDV is specified for the copy source of the SnapOPC copy session.
A standard volume was specified as copy destination volume in SnapOPC+.
An OLU is specified for the copy destination of the SnapOPC copy session.
An error, which can be recovered by retry, occurred.
An event occurred that should be retried.
The storage is in "Not Ready" or internal error state.
The ETERNUS DX is in NotReady status or an error event occurred in the firmware.
The specified volume is currently configured with Bind-in-Cache extent. RAID Migration cannot apply to
this volume.
RAID Migration cannot be performed for the specified LU because Bind-in-Cache is running for the LU.
The previous generation session is Readying
The latest generation was attempted to be set for the SnapOPC+ session with a generation in Readying
Session status.
The restore OPC can not start by using concurrent OPC.
A restoration OPC session was attempted to be set with Concurrent OPC.
The restore OPC of readying session can not start.
A restoration session was attempted to be set for a Readying session.
The specified copy range is overlap with the copy range in an existing xcopy session.
The copy destination area of a new session that is cascaded with a XCOPY session overlaps the copy
destination area of an existing XCOPY session or an XCOPY session that is to be restored.
The specified copy range is overlap with the copy range in an existing Readying or Copying OPC session.
The Concurrent OPC command attempted to overwrite an existing OPC session in Copying status or the
normal OPC start command attempted to overwrite an existing OPC session in Readying status.
The specified session can not restart because it is under restore.
A QuickOPC session that is being restored was attempted to be restarted with Concurrent OPC.
The specified remote box id is not support the out of band copy.
The ETERNUS storage system that is connected to start the REC does not support copying via a LAN
(Support is only available for connections between two ETERNUS DX S2 series systems or later).
In the remote old model storage, the specified volume is invalid.
An invalid volume is specified in the connection destination ETERNUS storage system that is an older
model.
In the remote old model storage, parameter error occurred.
A command parameter error occurred in the connection destination ETERNUS storage system that is an
older model.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
845
P2X0-1210-05ENZ0