Set Host-Wwn-Name - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-wwn-name

set host-wwn-name

This command changes an existing FC or FCoE host identifier.
■
Syntax
set host-wwn-name {-host-number
name
[-name
-host-response-name
■ Parameter
-host-number
or
-host-name
-wwn
-name
-host-response-number
or
-host-response-name
host_number
] [-host-response-number
host_response_name
This parameter specifies the FC or FCoE host identifier to be changed. If only the host response
identifier is being set, then two or more FC or FCoE host identifiers can be specified at the same
time. If not, then only one can be specified. For details, refer to
host_number
FC host number or FCoE host number
host_name
FC host name or FCoE host name
Optional. This parameter specifies the WWN to be changed. The WWN is a 16-byte
hexadecimal number. Only one parameter can be specified at the same time. If omitted, the
existing setting is not changed.
Example: -wwn 40000000abc78856
wwn
WWN
Optional. This parameter specifies the host WWN alias. Only one parameter can be specified at
the same time. For details, refer to
existing setting is not changed.
name
WWN alias
Optional. This parameter specifies the host response identifier to be changed. One or more
parameters can be specified at the same time. For details, refer to
Syntax" (page 28). If omitted, the existing setting is not changed.
host_response_number
Host response number
host_response_name
Host response name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
host_name
| -host-name
host_response_number
|
]
"1.2.5 Alias Name Syntax" (page
260
wwn
} [-wwn ]
"1.2.11 Host Syntax" (page
23). If omitted, the
"1.2.13 Host Response
P2X0-1210-05ENZ0
27).