Set Lun-Group - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set lun-group

set lun-group

This command changes an existing LUN group and can also be used to add a definition to the LUN group.
■
Syntax
set lun-group {-lg-number
[{-volume-number
■ Parameter
-lg-number
or
-lg-name
-name
-volume-number
or
-volume-name
source_lg_number
volume_numbers
| -volume-name
This parameter specifies the LUN group identifier to be changed. Only one LUN group can be
specified at the same time. For details, refer to
source_lg_number
LUN group number
source_lg_name
LUN group name
Optional. This parameter specifies the new LUN group name. Only one name can be specified
at the same time. If omitted, the existing setting is not changed.
name
New LUN group name
Optional. This parameter specifies the volume identifiers to add a definition to the specified
LUN group, and is paired with the "-lun" parameter. One or more parameters can be specified
at the same time. If omitted, the existing setting is not changed. For details, refer to
Volume Syntax" (page 26). If two or more LUNs are specified, these parameters must also be
specified in the same order as the associated volumes. Any already assigned definitions
cannot be specified.
Example:
-volume-number 10-12 -lun 1-3
-> The volume #10 and LUN 1 are pairs.
-> The volume #11 and LUN 2 are pairs.
-> The volume #12 and LUN 3 are pairs.
-volume-name v1,v2 -lun 1-2
-> The volume named "v1" and LUN 1 are pairs.
-> The volume named "v2" and LUN 2 are pairs.
volume_numbers
Volume number
volume_names
Volume name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
source_lg_name
| -lg-name
volume_names
} {-lun
"1.2.12 LUN Group Syntax" (page
328
name
} [-name ]
luns
}]
28).
"1.2.10
P2X0-1210-05ENZ0