Fujitsu Eternus DX100 S3 User Manual page 488

Chapter 5 System Settings and Display
5.1 User Management > set radius
-primary-port
-primary-port-number
-primary-authentication-mode
-primary-shared-secret
-primary-retry-timeout
Optional. This parameter specifies the port number of the primary server for the authentication
protocol.
maintenance
MNT port
remote RMT port
Optional. This parameter specifies the UDP port number of the primary server for the
authentication protocol. Specify the port number within 1 to 5 digits. The port number cannot
be set above 65535. If omitted, the existing setting is not changed. The default value is 1812.
port_number
UDP port number of the primary server
Optional. This parameter specifies the authentication method type of the primary server. If
omitted, the existing setting is not changed. The following methods can be specified:
chap Use CHAP. (Default)
pap Use PAP.
PAP: Password Authentication Protocol
Optional. This parameter specifies the shared secret of the primary server (up to 64
alphanumeric characters). If omitted, the existing setting is not changed.
shared_secret_code
Shared secret of the primary server
Optional. This parameter specifies the retry timeout value of the primary server. If omitted, 30
seconds (default value) is used. The timeout value should be selected from following values:
10 10 seconds
20 20 seconds
30 30 seconds (Default value)
40 40 seconds
50 50 seconds
60 60 seconds
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
488
P2X0-1210-05ENZ0