Eco-Mode Management - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.1 RAID Group Management
3.1.3

Eco-mode Management

This section explains the commands that are related to the Eco-mode functions. They are only applicable
when the Eco-mode is enabled using the "set eco-mode" command.
The commands described in this section are not supported in the ETERNUS DX200F.
The three steps involved in enabling the Eco-mode functions are as follows:
Procedure
1
Enable the Eco-mode.
2
Create an Eco-mode schedule.
3
Assign the Eco-mode schedule to RAID groups.
88
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
End of procedure
P2X0-1210-05ENZ0