Chapter 8 CLI Original Function
8.1 CLI Environment > set clienv-idle-timeout
set clienv-idle-timeout
This command sets the idle timeout interval until an idle status CLI session is automatically logged off. The
idle timeout interval applies to sessions that are created after the timeout interval is set. The timeout interval
for a session with the Software Control policy is 30 minutes (default setting) regardless of the setting of this
command. The timeout interval that is set by this command is shared in the ETERNUS DX.
■
Syntax
set clienv-idle-timeout [-timeout
■
Parameter
-timeout
■
Example(s)
The following example sets the idle timeout interval to 60 minutes:
CLI> set clienv-idle-timeout -timeout 60
The following example displays the current idle timeout interval for the ETERNUS DX:
CLI> set clienv-idle-timeout
CLI Idle Timeout (minute)
minute
This parameter specifies the idle timeout interval in minutes until an idle status CLI session is
automatically logged off. Any value from 5 minutes to 60 minutes can be specified. If omitted,
the current idle timeout interval is displayed.
minute
Idle timeout interval until an idle status CLI session is automatically logged off
(5 – 60)
[60]
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
]
823
P2X0-1210-05ENZ0