Fujitsu Eternus DX100 S3 User Manual page 500

Chapter 5 System Settings and Display
5.2 Network Management > set network
-primary-dns-ip
-secondary-dns-ip
-wake-on-lan
■
Example(s)
The following example sets up network parameters for the Maintenance port (MNT port). The IP address is
"192.168.1.100", and the subnet mask is "255.255.255.0":
CLI> set network -port maintenance -master-ip 192.168.1.100 -netmask 255.255.255.0
The following example sets up network parameters for the Maintenance port (MNT port). The IP address is
"10.10.10.1", the subnet mask is "255.255.0.0", and the gateway address is "10.10.10.250"; accessible
terminals are all addresses on the "10.11.0.0" network, and the single host address "192.168.1.1":
CLI> set network -port maintenance -master-ip 10.10.10.1 -netmask 255.255.0.0 -gateway 10.10.10.250 -allow-
ip1 10.11.0.0,255.255.0.0 -allow-ip2 192.168.1.1
The following example changes the Ethernet speed of the maintenance port (MNT port) to 100Mbit/s full-
duplex:
CLI> set network -port maintenance -speed 100full
Optional. This parameter specifies the primary DNS IP address for the Ethernet port. The format
is IPv4 standard notation (a base 256 "d.d.d.d" string) or IPv6 format. The types of IPv6
addresses that can be specified are global unicast addresses (including 6to4 addresses) and
unique local unicast addresses. This parameter cannot be specified when "-port fst" is
specified. If omitted, the existing setting is not changed.
When "v4" is specified for the "-ip-format" parameter, the IP addresses must be specified using
IPv4 standard notation. When "v6" is specified for the "-ip-format" parameter, the IP addresses
must be specified in IPv6 address format. This parameter cannot be specified when "-port fst" is
specified.
ip_address
Primary DNS IP address
Optional. This parameter specifies the secondary DNS IP address for the Ethernet port. The
format is IPv4 standard notation (a base 256 "d.d.d.d" string) or IPv6 format. The types of IPv6
addresses that can be specified are global unicast addresses (including 6to4 addresses) and
unique local unicast addresses. This parameter cannot be specified when "-port fst" is speci-
fied. If omitted, the existing setting is not changed. When "v4" is specified for the "-ip-format"
parameter, the IP addresses must be specified using IPv4 standard notation. When "v6" is
specified for the "-ip-format" parameter, the IP addresses must be specified in IPv6 address
format. This parameter cannot be specified when "-port fst" is specified.
ip_address
Secondary DNS IP address
Optional. This parameter specifies whether or not the Wake on LAN (WOL) function is enabled.
This function can be independently set for each Ethernet port (MNT/RMT). The initial value is
disabled. This parameter cannot be specified when "-port fst" selected. If omitted, the existing
setting is not changed. This parameter cannot be specified when "-port fst" is specified.
enable Wake on LAN is enabled.
disable Wake on LAN is disabled.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
500
P2X0-1210-05ENZ0