Set Iscsi-Parameters - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters

set iscsi-parameters

This command sets up the parameters of each iSCSI host interface port. It can also be used to change Host
Affinity Mode.
■ Syntax
set iscsi-parameters -port {
[-additional-ip
[-host-affinity {enable | disable}]
[-iscsi-name {
[-alias-name
[-host-response-number
[-reset-scope {initiator-lun | target-lun}] [-reserve-cancel {enable | disable}]
[-ipv4-flag {enable | disable}] [-ip
[-ipv6-flag {enable | disable}] [-link-local-ip
[-ipv6-gateway {
tcp_port_number
[-tcp-port
[-isns-server-ip
[-isns-server-port
[-chap {enable | disable}] [-chap-user {
[-header-digest {enable | disable}] [-data-digest {enable | disable}]
[-jumbo-frame {enable|disable}]
[-rate {auto|1gauto|10gauto|1gfull|100mfull}]
[-cmdsn-count {unlimited|20|40|80|120|180}]
[-vlan-id {enable | disable}] [-vlan-id-value {0 - 4095}]
[-mtu mtu_size
[-chap-ca {enable | disable}]
[-chap-user-ca {
[-chap-ra {enable | disable}]
[-chap-user-ra {
[-rec-line-no
[-rec-transfer-sync {enable|disable}] [-rec-transfer-stack {enable|disable}]
[-rec-transfer-consistency {enable|disable}] [-rec-transfer-through {enable|disable}]
[-tfo-transfer-mode {enable|disable}]
■
Parameter
-port
port_numbers
additional-ip ] [-additional-ip-function {enable | disable}]
iscsi_name
| ""}]
alias_name
]
host_response_number
ip_address
gateway
| auto}]
] [-tcp-window-scale
isns_server_ip
] [-isns-server {enable | disable}]
isns_server_port_number
chap_user_name
] [-bandwidth bandwidth_limit
chap_user_name
| ""}]
chap_user_name
| ""}]
rec-line-no
]
This parameter specifies which iSCSI interface port is to be set. Multiple comma-separated
ports may be specified.
Example: -port 000,110
For details, refer to "1.2.15 Host Interface Port Syntax" (page
port_numbers
iSCSI interface port number in "
"x" is the controller module (CM) number, "y" is the CA number, and "z" is the iSCSI port
number.
Example: 110 (CM#1, CA#1, iSCSI port#0)
all All iSCSI interface ports
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
| all} [-multiple-vlan {enable | disable}]
| -host-response-name
] [-netmask netmask ] [-gateway
ip_address
] [-connect-ip {
tcp_window_scale
]
]
| ""}]
]
xyz
" format
239
host_response_name
]
gateway ]
ip_address
| auto}]
29).
P2X0-1210-05ENZ0