Fujitsu Eternus DX100 S3 User Manual page 499

Chapter 5 System Settings and Display
5.2 Network Management > set network
-allow-ip1
. . .
-allow-ip16
-speed
Optional. These parameters specify IP addresses or network addresses that are permitted to
connect to this system. A maximum of 16 IP addresses can be specified. The types of IPv6
addresses that can be specified are global unicast addresses (including 6to4 addresses) and
unique local unicast addresses. If omitted, no changes are made to the table of allowed
addresses. This setting is not required to allow connection from the local sub-network (sub-
network to which the system network addresses belong). This parameter can only be specified
when "v6" is specified for the "-ip-format" parameter and "disable" is specified for the "-ipv6-
set-auto" parameter, or when "v4" is specified for the "-ip-format" parameter. This parameter
cannot be specified when "-port fst" is specified.
ip_address,netmask
IP address or network address
Example: Specify the following parameter to only permit access from a terminal
host that has the IP address "192.168.1.2":
"-allow-ip1 192.168.1.2"
Example: Specify the following parameter to only permit access from a terminal
host that has the IP address "2001:d53:c51::78:332"
"-allow-ip1 2001:d53:c51::78:332"
Example: Specify the following parameter to permit access from all terminals
that have the IP address "192.168.3.1" to "192.168.3.254" and the subnet mask
is "255.255.255.0":
"-allow-ip1 192.168.3.1,255.255.255.0"
Example: Specify the following parameter to permit access from the network that
has the network address "2001:d53:c51:78::", and set "64" for the subnet prefix
length:
"-allow-ipl 2001:d53:c51:78::.64"
Example: Specify the following parameter to delete an IP address:
"-allow-ip1 0.0.0.0,0.0.0.0" (IPv4)
"-allow-ip1 0,0" (IPv6)
Optional. This parameter specifies the connection speed of the specified Ethernet port. If
omitted, the existing setting is not changed.
1000 1Gbit/s
100full 100Mbit/s full-duplex
100half 100Mbit/s half-duplex
10full 10Mbit/s full-duplex
10half 10Mbit/s half-duplex
auto Auto negotiation
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
499
P2X0-1210-05ENZ0