Fujitsu Eternus DX100 S3 User Manual page 505

Chapter 5 System Settings and Display
5.2 Network Management > set firewall
■ Parameter
-port
-http
-https
-telnet
-ssh
-maintenance-secure
-icmp
This parameter specifies the Ethernet port. For details, refer to
Server" (page 35).
maintenance
MNT port
remote RMT port
fst FST port
"fst" is not supported in the ETERNUS DX100 S3/DX200 S3 and the ETERNUS DX200F.
Optional. This parameter specifies if the "http" application port is opened or closed. If omitted,
the existing setting is not changed. The initial state is "open".
open Application port "http" is opened.
close Application port "http" is closed.
Optional. This parameter specifies if the "https" application port is opened or closed. If omitted,
the existing setting is not changed. The initial state is "open".
open Application port "https" is opened.
close Application port "https" is closed.
Optional. This parameter specifies if the "telnet" application port is opened or closed. If
omitted, the existing setting is not changed. The initial state is "open".
open Application port "telnet" is opened.
close Application port "telnet" is closed.
Optional. This parameter specifies if the "SSH" (Secure Shell) application port is opened or
closed. If omitted, the existing setting is not changed. The initial state is "open".
open Application port "SSH" is opened.
close Application port "SSH" is closed.
Optional. This parameter specifies if the "ETERNUS Maintenance Secure (PCCT Secure)"
application port, which is used to connect to the monitoring software, is opened or closed. If
omitted, the existing setting is not changed. The initial state is "open".
open Application port "ETERNUS Maintenance Secure" is opened.
close Application port "ETERNUS Maintenance Secure" is closed.
Optional. This parameter specifies if the "ICMP"" (Internet Control Message Protocol)
application port is opened or closed. If omitted, the existing setting is not changed. The initial
state is "open".
open Application port "ICMP" is opened.
close Application port "ICMP" is closed.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
505
"1.11 Note for Specifying FTP
P2X0-1210-05ENZ0