Show Event-Parameters - Fujitsu Eternus DX100 S3 User Manual

Chapter 6 Information Settings and Display
6.4 Utility > show event-parameters

show event-parameters

This command displays the parameters set by the "set event-parameters" command.
■
Syntax
show event-parameters
■ Parameter
No parameters.
■ Output
Blink Panel Fault LED
Redundant Copy Fault LED
■ Example(s)
The following example displays the event parameters:
CLI> show event-parameters
Blink Panel Fault LED
Redundant Copy Fault LED [Enable ]
Indicates whether the Panel Fault LED is blinked when the system status is warning
Indicates whether the Fault LED lights up when the redundant copy is complete
[Enable ]
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
715
P2X0-1210-05ENZ0