Fujitsu Eternus DX100 S3 User Manual page 255

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set fcoe-parameters
■ Example(s)
The following example sets up the parameters to control the FCoE interface port #0 on CM#1 CA#1. Host
Affinity Mode is disabled:
CLI> set fcoe-parameters -port 110 -host-affinity disable
The following example sets up the parameters to control the FCoE interface port #1 on CM#0 CA#0. The FC
frame size is 2048 bytes, FCF VLAN ID 55, FCF Fabric name 0001000100010001:
CLI> set fcoe-parameters -port 001 -frame-size 2048 -fcf-vlan-id enable -fcf-vlan-id-value 55
-fcf-fabric-name enable -fcf-fabric-name-value 0001000100010001
255
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0