Set Volume - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.2 Volume Management > set volume

set volume

This command changes the registered volume information.
The "set flexible-tier-volume" command is used to change a Flexible Tier Volume (FTV).
Encryption-related functions may not be available for some user environments.
■
Syntax
set volume {-volume-number
[-copy-protection {enable | disable}] [-attention
[-uid uid | default | original] [-alua {follow-host-response | active | passive}]
■ Parameter
-volume-number
or
-volume-name
-name
-copy-protection
-attention
volume_number
This parameter specifies the volume identifier to be changed. Only one volume can be
specified at the same time. For details, refer to
volume_number
Volume number
volume_name
Volume name
Optional. This parameter specifies the new volume name. If omitted, the existing setting is not
changed. For details, refer to
name
Volume name
Optional. This parameter protects a volume from being specified for the copy destination. It is
possible to set it even when there is already a copy session. The copy license is necessary for
this setting. If this parameter is omitted, "disable" is set.
enable Volume is protected at the copy destination.
disable Volume is not protected at the copy destination.
Optional. This parameter specifies the attention level of the Thin Provisioning Volume (TPV).
This parameter can be specified when the volume type is TPV. The settable range is 1 – 100%.
If this parameter is omitted, attention level is not changed.
attention
Attention level of the Thin Provisioning Volume (TPV)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
volume_name
| -volume-name
attention
] [-encryption {enable | disable}]
"1.2.10 Volume Syntax" (page
"1.2.10 Volume Syntax" (page
125
name
} [-name ]
26).
26).
P2X0-1210-05ENZ0