Fujitsu Eternus DX100 S3 User Manual page 868

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
ED21D
ED21E
ED21F
ED220
ED221
ED222
ED223
ED224
ED225
ED226
ED227
ED228
ED229
ED22A
ED22B
ED22C
ED22D
ED22E
ED230
A timeout occurred during firmware registration.
A timeout occurred during firmware registration.
A checksum error occurred.
A checksum error occurred.
The size of the archive in the header is not corresponding to the size of the forwarding archive.
The size of the archive in the header is not the same as the size of the forwarding archive.
The disk where the archive that tries to be registered can be applied doesn't exist in the device.
The ETERNUS DX contains no disks that the target archive for registration can be applied to.
The archive that tries to be registered is unsupported firmware.
The archive that is to be registered is unsupported firmware.
Reading the history data failed.
Reading of the history data failed.
Reading the composition data failed.
Reading of the configuration data failed.
Writing the history data failed.
Writing of the history data failed.
Keeping the composition data failed.
Writing of the configuration data failed.
Keeping the newest composition data failed.
Writing of the "newest" configuration data failed.
The configuration is internally being updated.
The configuration is internally being updated. Wait for a while and try again.
Reading from a BUD failed.
Reading from a BUD failed. Wait for a while and try again.
The BUD doesn't exist.
The BUD does not exist. Wait for a while and try again.
The target module does not exist.
The target module does not exist. Check the input content.
The process cannot be performed because another function is being executed.
The process cannot be performed because another function is being executed. Wait for a while and try
again.
The revision that changes the Advanced Copy version cannot be performed because an EC, an OPC, or an
REC is running.
The revision that changes the Advanced Copy version cannot be performed because an EC, an OPC, or an
REC is running.
The execution was canceled because an error occurred during communication with the CM.
The execution was canceled because an error occurred during communication with the CM.
The firmware application or EC switch has not executed.
The firmware is not applied or the EC is not switched.
The EC switching operation that changes the Advanced Copy version is attempted while an EC, an OPC, or
a REC is running.
The EC switching operation that changes the Advanced Copy version is attempted while an EC, an OPC, or
an REC is running.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
868
P2X0-1210-05ENZ0