Show Events - Fujitsu Eternus DX100 S3 User Manual

Chapter 6 Information Settings and Display
6.2 Event Log Information > show events

show events

This command displays event information which has occurred in the system. The events displayed can be
narrowed down by specifying various parameters. If all the parameters are omitted, all events are displayed. If
multiple parameters are specified, the events displayed function according to the parameters that are set.
■ Syntax
show events [ -severity { information | warning | error } ] [ -cm {0|1|2|3|4|5|6|7} ] [ -count
■ Parameter
-severity
-cm
-count
Optional. This parameter specifies the severity of the event level. When severity is specified,
the display is restricted to information about events of the specified severity level. Only one
level can be specified at the same time. If omitted, all the events of the severity levels are
displayed.
information Information level
warning Warning level
error Error level
Optional. This parameter specifies the controller module number. Only events for the specified
CM are displayed. If omitted, all the events of all CMs are displayed.
0 CM#0
1 CM#1
2 CM#2
3 CM#3
4 CM#4
5 CM#5
6 CM#6
7 CM#7
Optional. This parameter limits how many events are displayed, selecting from the latest event
and working backward. If omitted, all the events are displayed.
count
Number of events that are displayed
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
673
count ]
P2X0-1210-05ENZ0